PT - JOURNAL ARTICLE AU - Kane, Brian AU - Brena, Sergio AU - Autio, Wesley TI - Forces and Stresses Generated During Rigging Operations AID - 10.48044/jauf.2009.013 DP - 2009 Mar 01 TA - Arboriculture & Urban Forestry (AUF) PG - 68--74 VI - 35 IP - 2 4099 - http://auf.isa-arbor.com/content/35/2/68.short 4100 - http://auf.isa-arbor.com/content/35/2/68.full AB - Rigging is one of the most dangerous aspects of arboriculture, yet there are no robust studies of the forces and stresses generated during rigging. Compounding the inherent danger of rigging is the structurally-deficient condition of many trees that are removed using rigging. Red pines (Pinus resinosa Ait.) (n = 13) were removed using conventional techniques, and forces at the block and in the rope were measured as the top, and four subsequent pieces were rigged with a block and Port-A-Wrap. Stress in the trunk at breast height was calculated from strain measurements and each tree’s modulus of elasticity. Multiple regression was used to determine which independent variables (mass of piece, fall distance and fall ratio, notch angle and depth) best predicted forces. Tops and pieces exhibited different relationships with mass, which was the best predictor of force at the block and tension in the rope. Other variables were not as important and exhibited counter-intuitive relationships with forces. There were few differences in stress generated when removing tops and pieces, which appeared to be due to greater deflection higher in the trunk when tops were removed.